48v 100ah lfp 5kw solar energy storage battery system 51.2V 200ah lifepo4 power wall
Power Storage System
This product is the lithium iron phosphate battery pack (including BMS) designed and manufactured by our company.It is composed of 16 battery cells, the battery group using intelligent sorting, accurate and reliable;BMS uses a professional protection panel test system to conduct a comprehensive test before going online to ensure that BMS can achieve comprehensive and effective protection of the battery pack during use.This product has high energy density, long life, safe and reliable, light weight, wide temperature range and other characteristics, is your reliable green environmental protection products.
Cell 电芯 |
Model 规格型号 |
LF100M-50160-100Ah |
Capacity 容量 |
100Ah |
|
Rated Voltage 标称电压 |
3.2V |
|
Internal Resistance 内阻标准 |
≤0.5 mΩ |
|
Combination Standard 配组标准 |
|
Pile Index 成品参数
|
Nominal voltage 标称电压 |
51.2V |
Nominal capacity 标称容量 |
100Ah |
|
Combination 组合方式 |
16S |
|
Standard Charge 标准充电 |
Sustained current持续电流:10A Cut-off current截止电流:0.01CA |
|
Standard discharge current 标准放电电流 |
(0.5C) |
|
The factory voltage 出厂电压 |
50.4V – 52V |
|
Self-discharge 自放电率 |
≤2%/月month |
|
Monitoring and control communications 监控通信 |
RS232、RS485 Port: Serial port communication RS232、RS485接口:串口通讯 |
|
work environment 工作环境 |
temperature:-20℃~﹢60℃;humidity:≤95%;At an altitude of:≤4000m 温度:-20℃~﹢60℃;湿度:≤95%;海拔:≤4000m |
|
Product Dimensions 电池组结构尺寸W×D×H(mm) |
442×440×133mm(3U) |
|
Net Weight 电池重量 |
45±1KG |
|
installation 安装方式 |
19 inch rack type, wall mounted, outdoor hanging wall type, pole type, floor type, longmen frame installation 19英寸机架式、壁挂式、室外挂墙式、抱杆式、落地式、龙门架安装 |
|
Minimum battery capacity standard 电池最小容量标准 |
≥95% |
|
Differential pressure between battery charging and discharging ends 电池充放电末端压差 |
≤300mV |
Management system 管理系统 |
Cell overcharge protection 单体过充保护 |
Cell Over Charging alarm voltage 单体过充告警电压 |
3550mV |
Can be set 可设 |
|
Cell Over Charge protection voltage 单体过充保护电压 |
3750mV |
Can be set 可设 |
|||
Cell Over Charging protection delay 单体过充保护延时 |
1.0S |
Can be set 可设 |
|||
Cell over voltage protection is removed 单体过压保护解除 |
Cell overcharge protection and restoration 单体过充保护解除电压 |
3500mV |
Can be set 可设 |
||
Cell over discharge protection voltage 单体过放保护 |
Cell Over discharging alarm voltage 单体过放告警电压 |
2650mV |
Can be set 可设 |
|
|
Cell over discharge protection voltage 单体过放保护电压 |
2500mV |
Can be set 可设 |
|||
Cell over release protection delay 单体过放保护延时 |
1.0S |
Can be set 可设 |
|||
Cell over release protection is disabled 单体过放保护解除 |
Over discharge renew voltage 单体过放保护解除电压 |
2900mV |
Can be set 可设 |
||
Overall overcharge protection 总体过充保护 |
Overall overcharge alarm voltage 总体过充告警电压 |
57V |
Can be set 可设 |
|
|
Overall overcharge protection voltage 总体过充保护电压 |
57.60V |
Can be set 可设 |
|||
Overall overcharge protection delay 总体过充保护延时 |
1.0S |
Can be set 可设 |
|||
Overall over release protection is removed 总体过放保护解除 |
Overall over discharge protection discharge voltage 总体过放保护解除电压 |
45.00V |
Can be set 可设 |
||
Charge over current protection 充电过流保护 |
Charge over current alarm current 充电过流告警电流 |
110A |
Can be set 可设 |
|
|
Charge over current protection current 充电过流保护电流 |
120A |
Can be set 可设 |
|||
Charging over current protection delay 充电过流保护延时 |
10.0S |
Can be set 可设 |
|||
Charging over current recovery condition 充电过流恢复条件 |
It was resumed every 1 min for redetection and locked for 10 consecutive times. Battery discharge current detected.每隔 1min 恢复一次,进行重新检测,连续 10 次锁定;检测到电池有放电电流 |
||||
Discharge over current 1 Protection 放电过流1保护 |
Discharge over current 1 Indicates the alarm current 放电过流1告警电流 |
110A |
Can be set 可设 |
|
|
Discharge over current 1 Protects the current 放电过流1保护电流 |
120A |
Can be set 可设 |
|||
Discharge over current 1 Protection delay 放电过流1保护延时 |
10.0S |
Can be set 可设 |
|||
Over current recovery conditions 过流恢复条件 |
It was resumed every 1min for redetection and locked for 10 consecutive times. A valid charger or charging current is detected. 每隔 1min 恢复一次,进行重新检测,连续 10 次锁定;检测到有有效的充电器或充电电流 |
||||
Discharge over current 2 protection 放电过流2保护 |
Discharge over current 2 Protects current 放电过流2保护电流 |
160A |
Can be set 可设 |
|
|
Discharge over current 2 Protection delay 放电过流2保护延时 |
400mS |
Can be set 可设 |
|||
Secondary over current recovery condition 二级过流恢复条件 |
It was resumed every 1min for redetection and locked for 10 consecutive times. A valid charger or charging current is detected.每隔 1min 恢复一次,进行重新检测,连续 10 次锁定;检测到有有效的充电器或充电电流 |
||||
Short circuit protection 短路保护 |
Short circuit protection current 短路保护电流 |
560A |
Can be set 可设 |
-1000A至二级过流保护值 |
|
Short circuit protection delay 短路保护延时 |
100μS |
Can be set 可设 |
|||
Short circuit protection removed 短路保护解除 |
It was resumed every 1min for redetection and locked for 3 consecutive times. A valid charger or charging current is detected. 每隔 1min 恢复一次,进行重新检测,连续 3 次锁定;检测到有有效的充电器或充电电流 |
||||
MOS high temperature protection MOS高温保护 |
MOS Over temperature protection temperature MOS过温保护温度 |
100℃ |
Can be set 可设 |
|
|
MOS protection release temperature MOS保护解除温度 |
85℃ |
Can be set 可设 |
|||
Cell temperature protection 电芯温度保护 |
Low charge temperature Alarm temperature 充电低温告警温度 |
0℃ |
Can be set 可设 |
|
|
Charging low temperature protection temperature 充电低温保护温度 |
-5℃ |
Can be set 可设 |
|||
Management system 管理系统 |
Cell temperature protection 电芯温度保护 |
The low temperature protection of charging is removed 充电低温保护解除温度 |
0℃ |
Can be set 可设 |
|
Charge High temperature Indicates the alarm temperature 充电高温告警温度 |
60℃ |
Can be set 可设 |
|||
Charging high temperature Protection temperature 充电高温保护温度 |
65℃ |
Can be set 可设 |
|||
The charging high temperature protection removes the temperature 充电高温保护解除温度 |
50℃ |
Can be set 可设 |
|||
Discharge low temperature Indicates the alarm temperature 放电低温告警温度 |
-15℃ |
Can be set 可设 |
|||
Discharge low temperature protection temperature 放电低温保护温度 |
-20℃ |
Can be set 可设 |
|||
Discharge low temperature protection releases the temperature 放电低温保护解除温度 |
-15℃ |
Can be set 可设 |
|||
Discharge High temperature Indicates the alarm temperature 放电高温告警温度 |
55℃ |
Can be set 可设 |
|||
Discharge high temperature protection temperature 放电高温保护温度 |
65℃ |
Can be set 可设 |
|||
Discharge high temperature protection releases the temperature 放电高温保护解除温度 |
55℃ |
Can be set 可设 |
|||
Ambient temperature protection 环境温度保护 |
Ambient low temperature Indicates the alarm temperature 环境低温告警温度 |
-20℃ |
Can be set 可设 |
|
|
Ambient low temperature protection temperature 环境低温保护温度 |
-25℃ |
Can be set 可设 |
|||
Ambient low temperature The ambient low temperature is removed 环境低温保护解除温度 |
-20℃ |
Can be set 可设 |
|||
Ambient Temp Indicates the alarm temperature 环境高温告警温度 |
65℃ |
Can be set 可设 |
|||
Ambient high Protective temperature 环境高温保护温度 |
70℃ |
Can be set 可设 |
|||
Ambient high temperature The ambient temperature is removed 环境高温保护解除温度 |
65℃ |
Can be set 可设 |
|||
balancing 均衡功能 |
Equalizing on voltage 均衡开启电压 |
3500mV |
Can be set 可设 |
|
|
Open the voltage differential 开启压差 |
30mV |
Can be set 可设 |
- YF750 new dewalt tools powerstation camping 750wh Solar Power System Outdoor Handy Mobile Portable Power Station
- 2019 popular 300w portable power station for Outdoor camping and laptop , sine wave power bank station for electric tool
- YF500 Portable 220V Power Station 500Wh Solar Power Generator 135200mAh Emergency Power Supply
- Customized 48V 8.6Ah e-bike motor battery pack with 13S4P 18650 Li ion high power battery
- 1S2P 18650 4000mAh batteries pack for electonic toy gun and mosquito swatter